Dake B-10 Model Manual Utility Hydraulic Bench Press, 10 Ton Capacity, 23″ Length x 18″ Width x 36″ Height

The Dake B-10 type handbook utility hydraulic bench press uses a single-speed hydraulic handpump to decrease the ram with as much as 10 heaps of pressure to facilitate pressing and forming. The channel iron H-frame accepts huge and ponderous pieces, and the hoist adjusts the table height for correct positioning. The workhead is movable to adjustment for off-middle pressing. The hydraulic cylinder and pump care for will also be situated on all sides of The clicking to maximise workspace and luxury. The discharge valve turns to Unencumber the hydraulic force, initiating ram go back after downstroke. Ultimate the valve at any point all the way through the ram go back will halt the ram.

Two interchangeable ram noses are included: a flat nose piece to be used in same old pressing operations and a step-reduced nose piece for helping, positioning, or fitting into pieces whilst pressing. The 2 table plates supply strengthen all the way through pressing. The clicking has a gauge with a 2-half”-dia. show for force readings. The bottom has four 7/sixteen”-dia. holes for bench mounting. Mounting hardware isn’t included. Hydraulic oil isn’t included. Press requires a few assembly.

H is height, the vertical distance from the lowest to easiest point of The clicking; W is width, the horizontal distance from left to proper; L is duration, the horizontal distance from entrance to back.

Hydraulic presses use fluid force to transmit a compressive pressure, which stays constant all through the duration of the ram’s stroke. Steel forming is one not unusual use of a hydraulic press.

Dake Machine Gear manufactures arbor presses, hydraulic presses, drill presses, energy hammers, band and cold saws, belt grinders, tube benders, and auto feed methods. The corporate, based in 1887, is headquartered in Grand Haven, MI.

What’s within the Box?

• Dake B-10 press
• Flat ram nose
• Step-reduced ram nose
• (2) Table plates